WorldCIST'15 - 3rd World Conference on Information Systems and Technologies

Full Program »

Antenna for fifth generation (5G) using a EBG structure

Currently, there is a breakthrough in wireless networks - Wi-Fi - but also in studies on the optimization of antennas. This article was developed with the purpose of presenting an antenna applied for fifth generation (5G), operating at frequency of 28 GHz, using an EBG (Electromagnetic Band Gap) structure to obtain an increased bandwidth. With faster speed, lower latency and performance significantly greater than any other, shows up the internet of the future. The proposed antenna uses, as substrate, RT5880, Rogers Corporation, with 2.2 and relative permittivity of 0.009 loss tangent and multi-cylinder drilled in the ground plan of radius of 0.2 mm. Is not required no drilling in the substrate. To obtain the results, simulations and analysis of the structure under study was used the HFSS ™ program (High Frequency Structural Simulator). In view of the good results this antenna can be considered a good candidate for applications in 5G.

Author(s):

Humberto César Chaves Fernandes    
Department of Electrical Engineering, Federal University of Rio Grande do Norte, UFRN
Brazil

Almir Souza e Silva Neto    
Institute of Education, Science and Technology of Paraíba, IFPB
Brazil

Marta Laís de Macedo Dantas    
Institute of Education, Science and Technology of Paraíba, IFPB
Brazil

Joicy dos Santos Silva    
Institute of Education, Science and Technology of Paraíba, IFPB
Brazil

 

Powered by OpenConf®
Copyright ©2002-2013 Zakon Group LLC